Fault code No.
Item
2
Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
3
Wire harness continuity.
4
Installed condition of crank-
shaft position sensor.
Check for looseness or
pinching.
Check the gap (0.85 mm
(0.0335 in)) between the
crankshaft position sensor
and the generator rotor.
5
Defective crankshaft position
sensor.
6
Malfunction in ECU.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
12
Crankshaft position sensor: no normal signals are received
from the crankshaft position sensor.
Improperly connected
Connect the coupler securely
or replace the wire harness.
Open or short circuit
Replace the wire harness.
Between crankshaft position
sensor coupler and ECU
coupler.
gray–gray
Between crankshaft position
sensor coupler and joint con-
nector.
black/blue–black/blue
Between joint connector and
ECU coupler.
black/blue–black/blue
Improperly installed sensor
Reinstall or replace the
sensor.
Refer to "GENERATOR AND
STARTER CLUTCH" on
page 5-30.
Check the crankshaft posi-
tion sensor.
Refer to "CHECKING THE
CRANKSHAFT POSITION
SENSOR" on page 8-101.
Replace if defective.
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-93.
13
Intake air pressure sensor 1: open or short circuit detected.
Able to start engine
Able to drive vehicle
03
Displays the intake air pressure.
8-39
FUEL INJECTION SYSTEM
Crank the engine.
Fault code number is not dis-
played Service is finished.
Fault code number is dis-
played Go to item 3.
Crank the engine.
Fault code number is not dis-
played Service is finished.
Fault code number is dis-
played Go to item 4.
Crank the engine.
Fault code number is not dis-
played Service is finished.
Fault code number is dis-
played Go to item 5.
Crank the engine.
Fault code number is not dis-
played Service is finished.
Fault code number is dis-
played Go to item 6.