Yamaha FZ09E 2014 Service Manual page 454

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
06 Coolant temperature
07 Vehicle speed pulses
08 Lean angle sensor
• Upright
• Overturned
09 Fuel system voltage
(battery voltage)
13 Throttle position sensor
signal 2
• Fully closed position
• Fully open position
14 Accelerator position sen-
sor signal 1
• Fully closed position
• Fully open position
15 Accelerator position sen-
sor signal 2
• Fully closed position
• Fully open position
Item
When engine is cold: Dis-
plays temperature closer
to air temperature.
When engine is hot: Dis-
plays current coolant tem-
perature.
Vehicle speed pulse
0–999
Lean angle sensor output
voltage
0.4–1.4
3.7–4.4
Fuel system voltage
Approximately 12.0
9–23
94–108
12–22
97–107
10–24
95–109
9-7
Meter display
Compare the actually
measured coolant temper-
ature with the meter dis-
play value.
Check that the number
increases when the rear
wheel is rotated. The num-
ber is cumulative and
does not reset each time
the wheel is stopped.
Remove the lean angle
sensor and incline it more
than 65 degrees.
Set the start/engine stop
switch to " ", and then
compare the actually mea-
sured battery voltage with
the meter display value. (If
the actually measured bat-
tery voltage is low,
recharge the battery.)
Check with throttle valves
fully closed.
Check with throttle valves
fully open.
Check with throttle grip
fully closed position.
Check with throttle grip
fully open position.
Check with throttle grip
fully closed position.
Check with throttle grip
fully open position.
Procedure