Yamaha FZ09E 2014 Service Manual page 373

TIP
When the Yamaha diagnostic tool is connected to the vehicle, the operation of the multi-function meter
and indicators will be different from the normal operation.
EAS27462
TROUBLESHOOTING DETAILS
This section describes the measures per fault code number displayed on the meter. Check and service
the items or components that are the probable cause of the malfunction following the order given.
After the check and service of the malfunctioning part have been completed, reset the meter display
according to the reinstatement method.
Fault code No.:
Fault code number displayed on the meter when the engine failed to work normally.
Diagnostic code No.:
Diagnostic code number to be used when the diagnostic mode is operated. Refer to "DIAGNOSTIC
MODE" on page 8-36.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
Procedure
Item Probable cause of
malfunction and check
1 Connection of crankshaft
position sensor coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
1
12
Crankshaft position sensor: no normal signals are received
from the crankshaft position sensor.
Unable to start engine
Unable to drive vehicle
—
—
—
Maintenance job
Improperly connected 
Connect the coupler securely
or replace the wire harness.
8-38
FUEL INJECTION SYSTEM
O
Lg/L Lg/W
L Br
R
B/W
2
Confirmation of service
completion
Crank the engine.
Fault code number is not dis-
played  Service is finished.
Fault code number is dis-
played  Go to item 2.
R