Installing The Relay Arm; Installing The Rear Shock Absorber Assembly - Yamaha FZ09E 2014 Service Manual

1
2. Check:
• Bearings
• Oil seals
Damage/pitting  Replace.
3. Check:
• Collars
Damage/scratches  Replace.
EAS23272

INSTALLING THE RELAY ARM

1. Lubricate:
• Collars
• Oil seals
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Bearings "1"
(to the relay arm)
• Oil seals "2"
New
(to the relay arm)
Installed depth "a"
6.0 mm (0.24 in)
Installed depth "b"
7.0 mm (0.28 in)
Installed depth "c"
1.5–2.5 mm (0.06–0.10 in)
Installed depth "d"
0.5–1.5 mm (0.02–0.06 in)
TIP
• When installing the oil seals "2" to the relay
arm, face the character stamp of the oil seals
outside.
• When installing the connecting arms "4" to the
relay arm, face the 1RC mark of the connecting
arms outside.
REAR SHOCK ABSORBER ASSEMBLY
2
3. Relay arm
4. Connecting arm
5. Rear shock absorber assembly
A. Left side
B. Right side
EAS23311
INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY
1. Install:
• Rear shock absorber assembly
• Rear shock absorber assembly upper bolt
• Rear shock absorber assembly upper nut
• Relay arm bolt
• Relay arm nut
• Connecting arm lower bolt
• Connecting arm lower nut
TIP
• Install the rear shock absorber assembly upper
bolt, relay arm bolt and connecting arm lower
bolt from the left.
• When installing the rear shock absorber as-
sembly, lift up the swingarm.
• Install the rear shock absorber assembly with
the rebound damping adjusting screw facing
the left side of the vehicle.
2. Tighten:
• Rear shock absorber assembly upper nut
• Relay arm nut
• Connecting arm lower nut
4-65
a
1
c
1
2
4
d d
b
3
1
d d
b
a
c
2
4
2
5