Yamaha FZ09E 2014 Service Manual page 91

1. Clamp
2. Rear brake light switch lead
3. Positioning tape
4. O sensor coupler
2
5. Radiator fan motor coupler
6. Auxiliary DC jack
7. Headlight relay
8. Radiator fan motor lead
9. O sensor lead
2
10. Frame
11. Engine
12. Adapter bracket
13. Bracket
A. Insert the clamp into the long hole in the battery
box.
B. Route the rear brake light switch lead outside the
wire harness branch to the O
C. To the ECU coupler
D. Install the wire harness clamp to the vehicle before
performing "Q".
To install the clamp, refer to "Handlebar (front
view)".
E. When performing the "Q", turn the handlebar to
the right and position the wire harness as shown in
the illustration.
F. Connect the O sensor coupler, and then fasten to
2
the bracket. Make sure that the top of the coupler
does not protrude. It is okay if the cover is
deformed.
G. Fasten the O sensor lead with the clamp, and
2
then install it on the bracket.
H. Route the O sensor lead and the rear brake light
2
switch lead through the bracket guide.
I. Route the rear brake light switch lead outside
brake fluid reservoir hose.
J. It does not matter whether the O
the rear brake light switch lead is on top (bottom)
in the area shown in the illustration.
K. Connect the radiator fan motor coupler.
L. Insert the rubber bracket for the headlight relay so
that it touches the rib of the air scoop stay on the
vehicle.
M. Install the fuse box to the rubber bracket, and then
insert the rubber bracket so that it touches the rib
of the air scoop stay on the vehicle.
Make sure that the fuse box is not removed from
the rubber bracket.
N. Route the radiator fan motor lead behind the fuse
box.
O. Route the radiator fan motor lead rear side of the
vehicle respect to the wire harness.
P. Insert the clamp so that it touches the rim of the
frame.
Q. Fasten the grommet of the wire harness and main
switch lead with the clamp at the rear side of the
grommet and the center of the positioning tape.
Point the tip of the clamp outward, and then cut it.
R. Positioning tape for the main switch lead.
S. Fasten the O sensor lead with the holder.
2
T. Route O sensor lead inside to the protrusion of
2
the adapter bracket.
U. Inside vehicle
sensor lead.
2
sensor lead or
2
2-56
CABLE ROUTING