Yamaha FZ09E 2014 Service Manual page 97

1. Stator coil assembly lead
2. Oil level switch coupler
3. Rear brake light switch coupler
4. Sidestand switch coupler
5. Gear position sensor coupler 1
6. Gear position sensor coupler 2
7. Negative battery lead coupler
8. Lean angle sensor
9. Starter motor lead
10. Cover
11. Canister purge hose (hose joint to canister)
12. Fuel tank breather hose (fuel tank to rollover valve)
A. Leads on the front of the battery box are, from the
top of the vehicle, in the following order: starter
motor lead, stator coil assembly lead. The orders
for other leads do not matter.
B. Hook the speed sensor lead on the cutout of the
battery box, as shown in the illustration. Make sure
to route it in front of the oil level switch coupler.
C. Fasten the wire harness side of the oil level switch
lead to the battery box.
D. Fasten the rear brake light switch lead on the wire
harness with tape.
E. Fasten the sidestand switch lead of the wire har-
ness to the battery box.
F. Route the negative battery lead inside to the
branch of the O sensor lead and the rear brake
2
light switch lead, and through between the wire
harness and the frame. For rear side of the vehi-
cle, route it above the wire harness.
G. Fasten the wire harness side of gear position sen-
sor lead 1 to the battery box.
H. Fasten the wire harness side of gear position sen-
sor lead 2 to the battery box.
I. After connecting the speed sensor coupler, make
sure that the coupler edge on the lead side does
not protrude from the cover.
J. Route the wire harness between the canister
purge hose (hose joint to canister) and the fuel
tank breather hose (fuel tank to rollover valve).
K. For California only
2-62
CABLE ROUTING