b. Turn the main switch to "ON".
c. Measure the turn signal/hazard relay output
voltage.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS28050
CHECKING THE RELAY UNIT (DIODE)
1. Check:
• Relay unit (diode)
Out of specification Replace.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
TIP
The pocket tester or the analog pocket tester
readings are shown in the following table.
ELECTRICAL COMPONENTS
Continuity
Positive tester probe
sky blue "1"
Negative tester probe
black/yellow "2"
No continuity
Positive tester probe
black/yellow "2"
Negative tester probe
sky blue "1"
Continuity
Positive tester probe
sky blue "1"
Negative tester probe
black/red "3"
No continuity
Positive tester probe
black/red "3"
Negative tester probe
sky blue "1"
Continuity
Positive tester probe
sky blue "1"
Negative tester probe
sky blue/white "4"
No continuity
Positive tester probe
sky blue/white "4"
Negative tester probe
sky blue "1"
Continuity
Positive tester probe
blue/black "5"
Negative tester probe
black/red "3"
No continuity
Positive tester probe
black/red "3"
Negative tester probe
blue/black "5"
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the relay unit coupler from the
wire harness.
b. Connect the pocket tester ( 1) to the relay
8-99