Fault code No.
Item
Item
Probable cause of
malfunction and check
1
Condition of intake air pres-
sure sensor 1 hose.
Check the intake air pressure
sensor hose condition.
2
Defective intake air pressure
sensor 1.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
14
Intake air pressure sensor 1: hose system malfunction
(clogged or detached hose).
Maintenance job
Clogged or detached hose
Repair or replace the sensor
hose.
Execute the diagnostic
mode. (Code No. 03)
When engine is stopped:
Atmospheric pressure at the
current altitude and weather
conditions is indicated.
At sea level: Approx. 101 kPa
(757.6 mmHg, 29.8 inHg)
1000 m (3300 ft) above sea
level: Approx. 90 kPa (675.1
mmHg, 26.6 inHg)
2000 m (6700 ft) above sea
level: Approx. 80 kPa (600.0
mmHg, 23.6 inHg)
3000 m (9800 ft) above sea
level: Approx. 70 kPa (525.0
mmHg, 20.7 inHg)
When engine is cranking:
Make sure that the indication
value changes.
The value does not change
when engine is cranking.
Check the intake air pressure
sensor 1.
Replace if defective.
Refer to "CHECKING THE
INTAKE AIR PRESSURE
SENSOR" on page 8-109.
15
Throttle position sensor: open or short circuit detected.
Able/Unable to start engine
Able/Unable to drive vehicle
01, 13
8-42
FUEL INJECTION SYSTEM
Confirmation of service
completion
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played Service is finished.
Fault code number is dis-
played Go to item 2.