Yamaha FZ09E 2014 Service Manual page 263

3. Install:
• Friction plate 1
• Clutch plate
• Friction plate 2
TIP
• First, install a friction plate and then alternate
between a clutch plate and a friction plate.
• Install the last friction plate "1" offset from the
other friction plates "2", making sure to align a
projection on the friction plate with the punch
mark "a" on the clutch housing.
a
1
4. Install:
• Bearing
(into the pressure plate)
• Pull rod "1"
• Pressure plate "2"
• Clutch springs
• Clutch spring bolts "3"
Clutch spring bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
• Oil pump driven sprocket "4"
Oil pump driven sprocket bolt
15 Nm (1.5 m·kgf, 11 ft·lbf)
LOCTITE®
TIP
• Tighten the clutch spring bolts in stages and in
a crisscross pattern.
• Apply lithium-soap-based grease onto the pull
rod.
• Position the pull rod so that the teeth "a" face
towards the hole "b". Then, install the clutch
cover.
2
5-46
3
1
4
5. Install:
• Dowel pins
• Clutch cover gasket
• Clutch cover
• Cover
Clutch cover bolt
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
TIP
• Apply engine oil onto the bearing.
• Tighten the clutch cover bolts in stages and in
a crisscross pattern.
6. Install:
• Pull lever
TIP
• Install the pull lever with the "O" mark facing to-
ward lower side.
• When installing the pull lever, push the pull le-
ver and check that the punch mark "a" on the
pull lever aligns with the mark "b" on the clutch
cover. Make sure that the pull rod teeth and
pull lever shaft pinion gear are engaged.
CLUTCH
2
3
a
b
New