Fault code No.
Item
4
Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
5
Wire harness continuity.
6
Defective relay unit.
7
Defective clutch switch.
8
Malfunction in ECU.
42
Speed sensor: no normal signals are received from the speed
A
sensor.
B Neutral switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Improperly connected
Connect the coupler securely
or replace the wire harness.
Open or short circuit
Replace the wire harness.
Between ECU coupler and
relay unit coupler.
black/yellow–black/yellow
Between relay unit coupler
and clutch switch coupler.
black/yellow–black/yellow
black/red–black/red
Check the relay unit.
Refer to "CHECKING THE
RELAY UNIT (DIODE)" on
page 8-99.
Check the clutch switch.
Replace if defective.
Refer to "CHECKING THE
SWITCHES" on page 8-89.
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-93.
8-70
FUEL INJECTION SYSTEM
Execute the diagnostic
mode. (Code No. 21)
When the clutch lever is
released: "OFF"
When the clutch lever is
squeezed: "ON"
Correct indication Go to
item 9.
Incorrect indication Go to
item 5.
Execute the diagnostic
mode. (Code No. 21)
When the clutch lever is
released: "OFF"
When the clutch lever is
squeezed: "ON"
Correct indication Go to
item 9.
Incorrect indication Go to
item 6.
Execute the diagnostic
mode. (Code No. 21)
When the clutch lever is
released: "OFF"
When the clutch lever is
squeezed: "ON"
Correct indication Go to
item 9.
Incorrect indication Go to
item 7.
Execute the diagnostic
mode. (Code No. 21)
When the clutch lever is
released: "OFF"
When the clutch lever is
squeezed: "ON"
Correct indication Go to
item 9.
Incorrect indication Go to
item 8.