Removing The Handlebar; Checking The Handlebar; Installing The Handlebar - Yamaha FZ09E 2014 Service Manual

EAS22860

REMOVING THE HANDLEBAR

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Handlebar grip "1"
TIP
Blow compressed air between the left handlebar
and the handlebar grip, and gradually push the
grip off the handlebar.
3. Remove:
• Throttle cable housings "1"
• Throttle grip "2"
TIP
While removing the throttle cable housing, pull
back the rubber cover "3".
EAS22880

CHECKING THE HANDLEBAR

1. Check:
• Handlebar
Bends/cracks/damage  Replace.
EWA13690
WARNING
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
3
1
2
4-45
EAS22931

INSTALLING THE HANDLEBAR

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Lower handlebar holders
(temporarily)
• Handlebar "1"
• Upper handlebar holders "2"
Upper handlebar holder bolt
22 Nm (2.2 m·kgf, 16 ft·lbf)
ECA1RC1407
NOTICE
• First, tighten the bolts on the front side of
the upper handlebar holder, and then on
the rear side.
• Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
TIP
• Align the punch mark "a" on the handlebar with
the left side upper surface of the left lower han-
dlebar holder "3".
• The upper handlebar holders should be in-
stalled with the punch marks "b" facing for-
ward.
b
1
a
3. Tighten:
• Lower handlebar holder nuts
HANDLEBAR
2
3