Fault code No.
Item
2
Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
3
Wire harness continuity.
4
Defective lean angle sensor.
5
Malfunction in ECU.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
41
Lean angle sensor: open or short circuit detected.
Improperly connected
Connect the coupler securely
or replace the wire harness.
Open or short circuit
Replace the wire harness.
Between lean angle sensor
coupler and ECU coupler.
yellow/green–yellow/green
Between lean angle sensor
coupler and joint connector.
blue–blue
black/blue–black/blue
Between joint connector and
ECU coupler.
blue–blue
black/blue–black/blue
Execute the diagnostic
mode. (Code No. 08)
Replace if defective.
Refer to "CHECKING THE
LEAN ANGLE SENSOR" on
page 8-101.
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-93.
42
Speed sensor: no normal signals are received from the
A
speed sensor.
B Neutral switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Able to start engine
Able to drive vehicle
07
Vehicle speed pulse
0–999
8-63
FUEL INJECTION SYSTEM
Turn the main switch to "ON",
then to "OFF", and then back
to "ON".
Fault code number is not dis-
played Service is finished.
Fault code number is dis-
played Go to item 3.
Turn the main switch to "ON",
then to "OFF", and then back
to "ON".
Fault code number is not dis-
played Service is finished.
Fault code number is dis-
played Go to item 4.
Turn the main switch to "ON",
then to "OFF", and then back
to "ON".
Fault code number is not dis-
played Service is finished.
Fault code number is dis-
played Go to item 5.