Yamaha FZ09E 2014 Service Manual page 159

2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-38.
3. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
4. Install:
• Collars
• Brake caliper bracket
• Rear wheel
• Adjusting blocks
• Wheel axle
• Washer
• Wheel axle nut
TIP
• Do not install the brake caliper.
• Align the projection "a" in the swingarm with the
slot "b" of the brake caliper bracket.
• Install the adjusting block so that projection "c"
faces to the front of the vehicle.
a
c
A. Left side
B. Right side
5. Install:
• Rear brake caliper
• Rear brake caliper bolts
6. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-16.
7. Tighten:
• Wheel axle nut
• Rear brake caliper bolts
EWA13500
WARNING
Make sure the brake hose is routed properly.
TIP
When tightening the wheel axle nut, there
b
should be no clearance "a" between the adjust-
ing block "1" and adjusting bolt "2".
4-19
REAR WHEEL
Drive chain slack
5.0–15.0 mm (0.20–0.59 in)
Wheel axle nut
150 Nm (15 m·kgf, 108 ft·lbf)
Rear brake caliper bolt (front)
27 Nm (2.7 m·kgf, 20 ft·lbf)
Rear brake caliper bolt (rear)
22 Nm (2.2 m·kgf, 16 ft·lbf)
LOCTITE®
1
c
a
2