Lubricating The Steering Head; Checking The Chassis Fasteners; Lubricating The Brake Lever; Lubricating The Clutch Lever - Yamaha FZ09E 2014 Service Manual

▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5. Install:
• Upper bracket
Refer to "HANDLEBAR" on page 4-44.
EAS1RC1321

LUBRICATING THE STEERING HEAD

1. Lubricate:
• Upper bearing
• Lower bearing
• Bearing races
Recommended lubricant
Lithium-soap-based grease
EAS1RC1322

CHECKING THE CHASSIS FASTENERS

Make sure that all nuts, bolts, and screws are
properly tightened.
Refer to "CHASSIS TIGHTENING TORQUES"
on page 2-18.
EAS1RC1303

LUBRICATING THE BRAKE LEVER

Lubricate the pivoting point and metal-to-metal
moving parts of the lever.
Recommended lubricant
Silicone grease
EAS1RC1304

LUBRICATING THE CLUTCH LEVER

Lubricate the pivoting point and metal-to-metal
moving parts of the lever.
Recommended lubricant
Lithium-soap-based grease
EAS21710

LUBRICATING THE PEDAL

Lubricate the pivoting point and metal-to-metal
moving parts of the pedal.
Recommended lubricant
Lithium-soap-based grease
PERIODIC MAINTENANCE
EAS21380

ADJUSTING THE SHIFT PEDAL

TIP
The shift pedal position is determined by the in-
stalled shift rod length.
1. Measure:
• Installed shift rod length "a"
Incorrect  Adjust.
Installed shift rod length
256.9–258.9 mm (10.11–10.19 in)
2. Adjust:
• Installed shift rod length
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift pedal position.
Direction "a"
Installed shift rod length increases.
Direction "b"
Installed shift rod length decreases.
c. Tighten both locknuts.
d. Make sure the installed shift rod length is
within specification.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS1RC1323

CHECKING THE SIDESTAND

1. Check:
• Sidestand operation
Check that the sidestand moves smoothly.
3-19
a a
1
2 1
b a a
a b b