Assigning A Port To A Vlan When Using Port Vlan Mode; Specifying A Backbone Port; Specifying That A Port Is A Vlt Port - 3Com 1000 User Manual

5-10 C 5: A
HAPTER DVANCED
Assigning a Port to a VLAN When Using Port
VLAN Mode
In the Port ID field, enter the ID of the required
1
port.
In the VLAN ID field, enter the ID of the required
2
VLAN.
Select APPLY.
3
CAUTION: Initially, all Switch ports belong to the
Default VLAN (VLAN 1). This VLAN is the only one
that allows an SNMP Network Manager to access
the management agent of the unit. If you remove
all ports from VLAN 1, then an SNMP Network
Manager cannot manage the Switch.

Specifying a Backbone Port

In the Port ID field, type the ID of the required port.
1
In the VLAN ID field, type the ID of the required
2
VLAN.
In the Select Port Type field, select Backbone Port.
3
Select APPLY.
4
M
ANAGEMENT

Specifying that a Port is a VLT Port

To specify that a port is a VLT port, refer to
ting Up the Switch Ports"
To create a VLT link, the ports on both ends of the
link must be VLT ports.
"Set-
on page 4-12.