Outputting System Information To The Trap Buffer - 3Com 4210G Series Configuration Manual

To do...
Specify a log host and
configure the parameters when
system information is output to
the log host
Configure the output rules of
the system information
Specify the source IP address
for the log information
Configure the format of the
time stamp for system
information output to the log
host

Outputting System Information to the Trap Buffer

The trap buffer receives the trap information only, and discards the log and debugging information
even if you have configured to output them to the trap buffer.
To do...
Enter system view
Enable information center
Name the channel with a
specified channel number
Configure the channel through
which system information can
be output to the trap buffer and
specify the buffer size
Use the command...
info-center loghost host-ip
[ channel { channel-number |
channel-name } | facility
local-number ] *
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
info-center loghost source
interface-type interface-number
info-center timestamp
loghost { date | no-year-date |
none }
Use the command...
system-view
info-center enable
info-center channel
channel-number name
channel-name
info-center trapbuffer
[ channel { channel-number |
channel-name } | size
buffersize ] *
22-9
Remarks
Required
By default, the system does not
output information to a log host.
If you specify to output system
information to a log host, the
system uses channel 2
(loghost) by default.
Optional
Refer to Default output rules of
system information.
Optional
By default, the source interface
is determined by the matched
route, and the primary IP
address of this interface is the
source IP address of the log
information.
Optional
date by default.
Remarks
—
Optional
Enabled by default
Optional
Refer to Table 22-2 for default
channel names.
Optional
By default, system information
is output to the trap buffer
through channel 3 (known as
trapbuffer) and the default
buffer size is 256.