Coaxial Cable Connector Connection Method - Mitsubishi Electric GOT1000 Series Connection Manual

1.4.2

Coaxial cable connector connection method

The following describes the method for connecting the BNC connector (connector plug for coaxial cable) and the cable.

Solder the coaxial cable connectors properly.
Insufficient soldering may result in malfunctions.
Components of the BNC connector
Nut
Plug shell
A
Cut this portion of the outer sheath
Clamp
Washer
Gasket
Insulating material
Internal conductor
C
B
Solder here
Precautions for soldering
Note the following precautions when soldering the internal conductor and contact.
• Make sure that the solder does not bead up at the soldered section.
• Make sure there are no gaps between the connector and cable insulator or they do not cut into each other.
• Perform soldering quickly so the insulation material does not become deformed.
CAUTION
Washer Gasket
Clamp Contact
1.
2.
Nut
3.
Clamp and external
conductor
4.
5.
1. PREPARATORY PROCEDURES FOR MONITORING
1.4 Connection Cables for the Respective Connection
Structure of the coaxial cable
External conductor
Outer sheath
Insulating material
Internal conductor
Remove the external sheath of the coaxial cable with
dimensions as shown below.
Cable in use
3C-2V
5C-2V, 5C-2V-CCY
Pass the nut, washer, gasket, and clamp through the coaxial
cable as shown on the left and loosen the external conductor.
Cut the external conductor, insulting material, and internal
conductor with the dimensions as shown below.
Note that the external conductor should be cut to the same
dimension as the tapered section of the clamp and smoothed
down to the clamp.
Cable in use
3C-2V
5C-2V, 5C-2V-CCY
Solder the contact to the internal conductor.
Insert the connector assembly shown in
shell and screw the nut into the plug shell.
A
15mm
10mm
B C
6mm 3mm
7mm 5mm
into the plug
1 - 27
1
2
3
4
5
6
7
8