Mitsubishi Electric GOT1000 Series Connection Manual page 275


When inputting and outputting
General input device
(Push button,etc.)
Operation panel
General output device
(Lamp, relay)
Connection cable 1)
Connection diagram
Name
number
diagram 7)
General input device
(Push button, etc.)
diagram 8)
Operation panel
General output device
diagram 9)
(Lamp, relay)
diagram 10)
*1 The power supply of 24VDC must be applied for the external I/O unit.
When the power supply of the external I/O unit is stopped in the operation, the operation panel becomes nonfunctional.
For using the operation panel again, reset the GOT after supplying the power to the external I/O unit.
*2 When the connector/terminal block converter module is used, the maximum input points are 64 points.
*3 When starting, turn on the external power supply to the external I/O unit and turn on the GOT.
When turning off the external power supply, a system alarm occurs.
When a system alarm is generated, input/output cannot be performed.
In this case, turn on the main power of the GOT or reset the GOT.
(When bus connection is used, the reset switch on the GOT does not function.)
Connection cable 1)
Connection cable 1)
DC power supply
Connector/terminal block converter
module
A6TBY36-E
Connection
Connection diagram 7)
A6TBY54-E
Connection
Connection diagram 8)
A6TBY36-E
Connection
Connection diagram 9)
A6TBY54-E
Connection
Connection diagram 10)
Connector/terminal
block convertor
module
Connection cable 2)
Connection cable 2)
Connection diagram
*1*2
number
Connection
diagram 5)
Connection
diagram 6)
7. CONNECTION TO EXTERNAL I/O DEVICE
7.2 System Configuration
Extended function OS
External I/O /Operation panel
GOT
*3
GOT
Option device Model
GT15-DIO
GT15-DIOR
7 - 3
1
2
3
4
5
6
7
8