Mitsubishi Electric GOT1000 Series Connection Manual page 296


Setting of [Bar Code] of GT Designer3
Item
Read Data Direct Input to Object
Device
Device Points
*1
Header
*1
Terminator
Writing Byte Order
Fills a blank when Imported data is
not filled in Writing Points
Filling Data
*1 Keep consistency with the bar code reader setting.
POINT POINT POINT
[Bar Code] of GT Designer3
For the [Bar Code] setting in GT Designer3, refer to the
following manual.
GT Designer3 Version1 Screen Design Manual
9 - 6
9. BAR CODE READER CONNECTION
9.4 System Configuration Examples
Set value
No
D0
6
None
CR
Low High
Check (Filling Data is available)
Space (020)

Confirmation on PLC side
Connect GX Developer to the QCPU (Q-mode) and
check if the data, which has been read with the bar
code reader, are written in D0 to D5.
For the GX Developer operation method, refer to the
following manual.
GX Developer Version
(1) Confirming the device values of D0 to D5 (when
using GX Developer Version 8)
Startup procedure
GX Developer [Online]
batch]
ASCII codes are hexadecimals.
Specify [HEX] for [Value] of the GX
Developer and confirm the read data.
Operating Manual
[Monitor] [Device