Mitsubishi Electric GOT1000 Series Connection Manual page 62

3.

For GT10
1 - 34
1. PREPARATORY PROCEDURES FOR MONITORING
1.5 Verifying GOT Recognizes Connected Equipment
4.
1.
2.
3. 4.
3.
The [Communication Settings] appears.
4.
Verify that the communication driver name to
be used is displayed in the box for the
communication interface to be used.
5.
When the communication driver name is not
displayed normally, carry out the following
procedure again.
1.1Setting the Communication Interface
1.
After powering up the GOT, touch [Main menu]
[Communication setting] from the Utility.
2.
Touch [Standard I/F] on [Comm. Setting].
3.
The [Standard I/F] appears.
4.
Verify that the communication driver name to
be used is displayed in the box for the
communication interface to be used.
5.
When the communication driver name is not
displayed normally, carry out the following
procedure again.
1.1Setting the Communication Interface