Mitsubishi Electric GOT1000 Series Connection Manual page 168

Address
Clock data (year)
SD8
Clock data (day of week)
SD9
SD10 to 15
*1 If a wrong day of the week is set by the clock data setting commands, the clock data will differ from the time displayed on the
utility.
Example: When October 1, 2009 (Tuesday) is set by the clock data setting command (the actual day of the week is Thursday),
POINT POINT POINT
The side where virtual devices are set
System
User

Details and actions for errors (error codes) stored into SD2
Error code
0 No error
Parity error
1, 101
Framing error
2, 102
Overrun error
3, 103
Communication message error
4, 104
Command error
5
Timeout error
105
Multiple units not connectable
106
Clock data setting error
6, 107
3 - 12
3. MICROCOMPUTER CONNECTION (ETHERNET)
3.3 Device Data Area
4-digit year data is stored.
*1
Day-of-the-week data is stored.
0: Sunday 1: Monday
4: Thursday 5: Friday
"2" is stored to SD9 although Thursday (THU) will be displayed on the utility time display.
: Set on the system side.
: Set on the user side (by sending request messages from host or using the touch switches, etc.
on the GOT).
Description
The parity bit does not match.
The data bit and/or stop bit are not correct.
The next data was transmitted from the host before GOT
completes the processing of the data received.
EXT/CR could not be found before the upper limit of the
receive buffer was exceeded.
An unsupported command was used.
There is no response from the GOT, or the station of the
specified address does not exist.
The RS-232 port is occupied.
The setting value of the clock data has error.
Description
2: Tuesday 3: Wednesday
6: Saturday
Unused
• Check the communication cable and communication module
attachment.
• Check the settings of "Communication Detail Settings".
• Match the GOT and host transmission settings.
• Check the settings of "Communication Detail Settings".
• Decrease the transmission speed.
• Check the communication cable and communication module
attachment.
• Check the settings of "Communication Detail Settings".
• Review the contents of the message to transmit.
• Review the contents of the message to transmit.
• Check the commands in the message.
(
• Check the communication cable and communication module
attachment.
• Check the settings of "Communication Detail Settings".
• Review the contents of the message to transmit.
• Check the communication cable and communication module
attachment.
• Check the settings of "Communication Detail Settings".
• Check to see if the RS-232 port is occupied.
• Review the contents of the message to transmit.
• Check whether the non-existent data is set (e.g. setting "07"
at the day of the week) as clock data.
(From previous page)
Action
―
3.4.2 List of commands)
Set side
System
―