Reading Out Measured Values - DeDietrich AWHP 6 MR Installation And Service Manual

AWHP MIT-IN iSystem
5.5

Reading out measured values

0 2 4 6 8
E 1
2
1
D
2
bar
F
# 
% $
AUTO
J I
STD
User level - Menu #MEASURES
Parameter Description
Outside temperature
OUTSIDE TEMP.
Room temperature of circuit A
(1)
ROOMTEMP. A
Room temperature of circuit B
(1)
ROOMTEMP. B
Room temperature of circuit C
(1)
ROOMTEMP. C
Inside module flow sensor measurement
TEMP.MIT
Water pressure in the installation
PRESSURE
Water temperature in the DHW tank
(1)
WATER TEMP.
Water temperature in the storage tank
STOR.TANK.TEMP
(1)
Water temperature of the swimming pool on circuit B
SWIMMING P.T.B
(1)
Water temperature of the swimming pool on circuit C
SWIMMING P.T.C
(1)
Temperature of the flow water in circuit B
OUTLET TEMP. B
(1)
Temperature of the flow water in circuit C
OUTLET TEMP. C
(1)
(1) Temperature of the system flow water if multi-generator
SYSTEM TEMP.
Water temperature in the bottom of the DHW tank
T.DHW BOTTOM
(1)
(1) The parameter is only displayed for the options, circuits or sensors actually connected.
24/09/2012 - 300027606-001-01
10 12 14 16 18 20 22 24
SUNDAY 11:45
!
:
<
C002219-D-04
CAUTION
Check the water flow rate in the system, which must be
higher by at least 4 to 5 l/min than the MIN.MES.FLOW.
value. Check the parameter FLOWMETER.
¼ See chapter: "Reading out measured values", page
88.
If the flow rate is too low, clean the filter upstream of the
plate heat exchanger.
¼ See chapter: "Cleaning the 400 µm filter", page
104.
The various values measured by the appliance are displayed in the
#MEASURES menu.
1. To access user level: Press the > key.
2. Select the menu #MEASURES.
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer
to the chapter: "Browsing in the menus", page 75.
5. Commissioning
Unit
°C
°C
°C
°C
°C
bar
°C
°C
°C
°C
°C
°C
°C
°C
88