Table of Contents
Advertisement
Fig.16
Selecting the forcing desired
K
M
SERVICE
E
D
"
"
.
"
A
B
6.3
Reading out measured values
Fig.17
Information menu
K
M
SERVICE
E
D
"
"
.
"
A
B
Parameter
Description
Measured flow temperature
Measured domestic hot water temperature
Measured outside temperature
Water flow rate
Software version
Tab.15
Parameter
Description
Estimated electrical energy consumption in heating mode
Estimated electrical energy consumption in domestic hot water mode
7612035 - v02 - 12062014
!
C
D
!
C
D
In heating mode: Heating flow set point temperature
In domestic hot water mode: DHW set point temperature
In cooling mode: Cooling set point temperature
In swimming pool mode: Swimming pool set point temperature
2. Hold the A key down and press the D key successively to choose
the forcing desired.
Display
+
+
+
+
The symbol
disappears from
the display.
6.3.1 Displaying the measured values
1. Go to the Information menu (
See
Using the control panel, page 14.
2. Use the B ( ) and C (
Note
If no keys are pressed for 10 seconds, the screen goes back to
the main display. For permanent information display: When the
wording
flashes, press the A (
simultaneously.
The wording
3. Press the A (
) key to exit the menu.
Note
If the wording
to the main display after 5 seconds.
Information menu
6.3.2 Energy consumption display
Note
The energy consumption display is done after the information
menu
.
Back-up
Forcing the back-up for heating
Forcing the back-up for
domestic hot water
Forcing the back-up for heating
and domestic hot water
Back-up forcing deactivated
).
) keys to scroll through the information.
) and B ( ) keys
continues to be displayed and stops flashing.
is not displayed, the screen will switch back
(1)
.
(1)
AWHP-2 MIV-3 V220
6 Settings
Unit
°C
°C
°C
°C
litres/minute
Unit
kWh
kWh
19
Advertisement
Table of Contents
