DeDietrich AWHP 6 MR Installation And Service Manual page 65

Air / water heat pump
Hide thumbs Also See for AWHP 6 MR:
Table of Contents

Advertisement

AWHP MIT-IN iSystem
Settings to be made for this type of installation
Parameters
Access
Installer level
INSTALLATION
#SYSTEM menu
Installer level
(1)
CIRC. A:
#SYSTEM menu
Installer level
PUMP MIT/MHR
#SYSTEM menu
Installer level
(1)
CIRC. B:
#SYSTEM menu
Installer level
CT.TEL
#SYSTEM menu
Installer level
I.TEL:
#SYSTEM menu
Installer level
DHW TYPE
#PRIMARY INSTAL.P menu
Installer level
BACKUP TYPE
#PRIMARY INSTAL.P menu
Installer level
HP BUS
#PRIMARY INSTAL.P menu
Installer level
CIRC.CURVE A
#SECONDARY INSTAL.P menu
(1) The parameter is only displayed if INSTALLATION parameter is set to EXTENDED
24/09/2012 - 300027606-001-01
Connect the DHW tank anode.
I
CAUTION
4
4
Not used: Do not connect anything to the terminal block.
O
Connect the motor on the DHW reversal valve.
P
Connect the EVU contact to the 1-2 terminals on the
a
TEL connector.
Connect the BUS cable between the outside module and
z
the terminal block on the inside module.
See chapter: ¼ "Connecting the communication
cable between the inside and outside modules", page
45.
Settings to be made
EXTENDED
DIRECT
CIRC. A:
3WV
CLOSE
0/1 EVU
SECONDARY
/E1: Stage1
/E2: Stage2
TOR
0.7
If the tank is fitted with a Titan Active
System® impressed current anode,
connect the anode to the inlet (+ TA on the
anode, - on the tank).
If the tank is not fitted with an impressed
current anode, put the simulation
connector in place (delivered with the DHW
sensor - package AD212).
See chapter
¼ "Displaying the parameters in
extended mode", page 78
¼ "Setting the parameters specific
to the installation", page 78
¼ "Setting the parameters specific
to the installation", page 78
¼ "Setting the parameters specific
to the installation", page 78
¼ "Setting the parameters specific
to the installation", page 78
¼ "Setting the parameters specific
to the installation", page 78
¼ "Professional settings", page
91
¼ "Professional settings", page
91
¼ "Professional settings", page
91
¼ "Professional settings", page
91
4. Installation
64

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents