DeDietrich AWHP 6 MR Installation And Service Manual page 94

5. Commissioning
Installer level - Menu #PRIMARY INSTAL.P
Parameter
MIT.PUMP.DELAY
BACKUP TYPE
INDVIDUAL.RELIEVE
BACKUP PUMP DEL.
TPO.APPOINT.SUP
TPO.APPOINT/ALLURE 0 to 10 min
WWE ZUSATZHEIZ
BOOSTER START DHW 0 to 50 min
BOOSTER TIMER DHW
DHW TYPE
HW. PUMP DELAY
DIF.COLD DHW
DHW PRODUCT DELAY 0 to 4 hours
DELAY BETWEEN ECS
BOOST DHW
(1) The menu is displayed only if the INSTALLATION parameter is set to EXTENDED
(2) The parameter is only displayed if the COOLING parameter is not set to OFF.
(3) Active when the BL contact is opened.
(4) Active when the BL contact is closed.
93
(1)
Adjustment range Description
0 to 99 min Post-operation time delay MIT pump
Nature of back-ups
/E1
/E1: 1 stage electrical back-up
/E2
/E2: 2 stage electrical back-up
/H
/H: Hydraulic additional heating
OFF / ON Generator power cut off
0 to 15 min Post-operation time back-up pump
0 to 50 min Additional time delay on tripping the
back-ups
Time delay between stages or time
delay on tripping the back-ups
Use of the electrical resistor in the tank
TANK
for DHW back-up
Use of the inside module back-ups for
MIT
DHW
Heating mode: Use of the inside module
MIT/D.COOL
back-ups for DHW
Cooling mode: Use of the electrical
resistor in the tank for DHW back-up
DHW back-up trip time delay
0 to 10 min DHW back-up stages trip time delay
Choice of the type of installation on the
PRIMARY
DHW circuit
SECONDARY
1 to 99 min Post-operation time delay ECS pump
5 to 30 °C DHW temperature differential to
activate the heat pump
Maximum duration of DHW production
0 to 4 hours Minimum time between two DHW
production runs
OFF / ON Acceleration of DHW production
systematically using the back-ups
AWHP MIT-IN iSystem
Factory setting Customer
setting
3 mn
OFF
4 mn
20 mn
4 mn
MIT
5 mn
5 mn
SECONDARY
3 mn
15°C
2 hours
2 hours
OFF
24/09/2012 - 300027606-001-01