Table of Contents
Advertisement
Replacing the air baffle
Use this information to replace the air baffle.
Note: When you install the second microprocessor, you must also install fan 2 and the air baffle that come
with the second microprocessor upgrade kit.
To replace the air baffle, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 163.
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3.
Remove the left-side cover (see "Removing the left-side cover" on page 187).
Step 4.
Remove the existing air baffle (see "Removing the air baffle" on page 189).
Step 5.
Touch the static-protective package that contains the air baffle; then, remove the air baffle from the
package.
Step 6.
Slide the air baffle down into the server until the tabs fit into the locating holes.
190
System x3300 M4 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
