Table of Contents
Advertisement
Replacing the left-side cover
Use this information to replace the left-side cover.
To install the server cover, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 34.
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3.
Slide the left-side cover over the server until the left-side cover edges slip into position over the
chassis.
Important: Before you slide the left-side cover forward, make sure that all the tabs on the cover
engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be hard
to remove the cover later.
Step 4.
Lock the left-side cover, using the key that comes with the server.
Connecting the cables
Use this information to connect the cables.
The following illustration shows the locations of the input and output connectors on the front of the server.
86
System x3300 M4 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
