Removing And Replacing Tier 1 Crus - Lenovo System x3300 M4 Installation And Service Manual

7. See the documentation that comes with the adapter for any cabling instructions and information about
jumper or switch settings. (It might be easier for you to route cables before you install the adapter.)
8. Align the battery holder with the guide pin to install the battery holder.
9. Make sure that the battery holder is secured firmly.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 83.

Removing and replacing Tier 1 CRUs

Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request, you will
be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Installing drives
The followings are illustrations of the server and the location of the drive bays. Your hardware might differ,
depending on the model.
Note: If the server is configured for RAID operation using a ServeRAID adapter, you might have to
reconfigure your disk arrays after you install drives. See the ServeRAID adapter documentation for additional
information about RAID operation and complete instructions for using the ServeRAID adapter.
The following illustrations show the location of the drive bays in the 2.5-inch and 3.5-inch hard disk drive
server models.
.
Chapter 6 Removing and replacing components
193