Lenovo System x3300 M4 Installation And Service Manual page 127

[access_method]
The access method that you select to use from the following methods:
• Online authenticated LAN access, type the command:
[host <imm_internal_ip>] [user <imm_user_id>][password <imm_password>]
Where:
imm_internal_ip
The IMM internal LAN/USB IP address. The default value is 169.254.95.118.
imm_user_id
The IMM account (1 of 12 accounts). The default value is USERID.
imm_password
The IMM account password (1 of 12 accounts). The default value is PASSW0RD (with a zero 0
not an O).
Note: If you do not specify any of these parameters, ASU will use the default values. When the
default values are used and ASU is unable to access the IMM using the online authenticated LAN
access method, ASU will automatically use the following unauthenticated KCS access method.
The following commands are examples of using the userid and password default values and not
using the default values:
Examples that do not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName <m/t_model>
–user <imm_user_id> –password <imm_password>
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum <s/n> –user <imm_user_id>
–password <imm_password>
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag <asset_tag>
–user <imm_user_id> –password <imm_password>
Examples that do use the userid and password default values:
asu set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
asu set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
asu set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this access method.
The KCS access method uses the IPMI/KCS interface. This method requires that the IPMI driver
be installed. Some operating systems have the IPMI driver installed by default. ASU provides the
corresponding mapping layer. You can download the ASU from the Lenovo website. To download the
Advanced Settings Utility Users Guide, complete the following steps.
Note: Changes are made periodically to the Lenovo website. The actual procedure might vary
slightly from what is described in this document.
a. Go to http://www.lenovo.com/support.
b. Click on the Downloads tab at the top of the panel.
c. Under ToolsCenter, select View ToolsCenter downloads.
d. Select Advanced Settings Utility (ASU).
e. Scroll down and click on the link and download the ASU version for your operating system. Scroll
down and look under Online Help to download the Advanced Settings Utility Users Guide.
The following commands are examples of using the userid and password default values and not
using the default values:
Examples that do not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName <m/t_model>
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum <s/n>
.
Chapter 3 Configuration information and instructions
113