Direct Cooling Air Baffle - Lenovo ThinkStation p910 Hardware Maintenance Manual

8. Route the cable of the new cover presence switch, and align the notch
with the tab 1 in the chassis. Then pivot the cover presence switch bracket to the right as shown until
it snaps into position.
Figure 14. Installing the cover presence switch bracket
9. Connect the cable of the new cover presence switch to the system board. See "Parts on the system
board" on page 35.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 213.

Direct cooling air baffle

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To remove the direct cooling air baffle, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 101.
2
1
2 on the cover presence switch
.
Chapter 9 Installing or replacing hardware
105