Returning A Device Or Component; Internal Cable Routing And Connectors - Lenovo System x3300 M4 Installation And Service Manual

Returning a device or component

If you are instructed to return a device or component, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Internal Cable Routing and Connectors

This section contains information about the internal cable routing and connectors.
The server uses cables to connect SATA attached, hot-swap SATA, hot-swap SAS and DVD drive devices to
the power supply and to the system board.
Review the following information before connecting power and signal cables to internal drives:
• The drives that are preinstalled in the server come with power and signal cables attached. If you replace
any drives, remember which cable is attached to which drive.
• When you route a cable, make sure that it does not block the airflow to the rear of the drives or over
the microprocessor or DIMMs.
Power Cable Connection
This section contains information about the power cable connection.
The following illustration shows the fixed power cable routing.
The following illustration shows the hot-swap power cable routing.
166
System x3300 M4 Installation and Service Guide