Lenovo System x3300 M4 Installation And Service Manual page 222

9. Install the EMC shields to the tape drive bay.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 83.
Replacing an optional tape drive
Use this information to replace an optional tape drive.
To replace an optional full-height tape drive, complete the following steps:
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 163.
2. Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
3. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 187).
4. Open the bezel (see "Removing the bezel" on page 185).
5. Remove the air baffle (see "Removing the air baffle" on page 189).
6. Remove the fan assembly (see "Removing the fan assembly" on page 39).
7. Remove the existing tape drive (see "Removing an optional tape drive" on page 207).
8. Touch the static-protective package that contains the DVD drive to any unpainted metal surface on the
server; then, remove the DVD drive from the package.
9. Install the drive rail on the tape drive, using the holes nearest the center of the drive.
10. Follow the instructions that come with the drive to set jumpers or switches, if there is any.
Note: You might find it easier to install the new drive from the front and then attach the cables.
11. Align the rails on the tape drive with the guides in the drive bay; then, slide the tape drive into the
drive bay until the rails click into place.
208
System x3300 M4 Installation and Service Guide