Lenovo System x3300 M4 Installation And Service Manual page 212

problem, always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
2. Unlock the left-side cover.
Note: You must unlock the left-side cover to open or remove the bezel. When you lock the left-side
cover, it locks both the cover and the bezel.
3. Open the bezel (see "Removing the bezel" on page 185).
4. Remove the existing 2.5-inch hot-swap hard disk drive (see "Removing a 2.5-inch hot-swap hard disk
drive" on page 196).
5. Touch the static-protective package that contains the 2.5-inch hot-swap hard disk drive; then, remove
the 2.5-inch hot-swap hard disk drive from the package.
6. Make sure that the tray handle is open; then, install the hard disk drive into the hot-swap bay.
7. Rotate the drive handle until the drive is seated in the hot-swap bay and the release latch clicks into
place.
Notes:
a. After you install the hard disk drive, check the disk drive status LEDs to verify that the hard disk drive
is operating correctly.If the yellow hard disk drive status LED is lit continuously, that drive is faulty and
must be replaced. If the green hard disk drive activity LED is flashing, the drive is being accessed.
b. If the server is configured for RAID operation through an optional ServeRAID adapter, you might have
to re-configure your disk arrays after you install hard disk drives. See the ServeRAID documentation
on the Lenovo ServeRAIDSupport CD for additional information about RAID operation and complete
instructions for using ServeRAID Manager.
8. Close the bezel.
9. Lock the left-side cover.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 83.
198
System x3300 M4 Installation and Service Guide