Lenovo System x3300 M4 Installation And Service Manual page 245

Machine type: 7382
Hide thumbs Also See for System x3300 M4:
Table of Contents

Advertisement

Attention: Do not lift the battery by using excessive force. Failing to remove the battery
properly may damage the socket on the system board. Any damage to the socket may require
replacing the system board.
Step 9.
Insert the new battery:
a.
Position the battery so that the positive (+) symbol is facing you.
b.
Place the battery into its socket until it clicks into place. Make sure that the battery clip holds
the battery securely.
Step 10. Install the cover (see "Replacing the left-side cover" on page 188).
Step 11. Reconnect the external cables and power cords; then, turn on the attached devices and turn on
the server.
Note: You must wait approximately 3 minutes after you connect the server power cord to an
electrical outlet before the power-control button becomes active.
Step 12. Start the Setup utility and reset the configuration:
1. Set the system date and time.
2. Set the power-on password.
3. Re-configure the server.
See "Starting the Setup utility" on page 93.
Step 13. Dispose of the battery as required by local ordinances or regulations. See the Lenovo Environmental
Notices and User's Guide on the Lenovo Documentation CD for more information.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 83.
Removing the front USB connector and operator information panel assembly
Use this information to remove the front USB connector and operator information panel assembly.
To remove the front USB connector and operator information panel assembly, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 163.
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3.
Disconnect all external cables and power cords.
.
Chapter 6
Removing and replacing components
231

Advertisement

Table of Contents
loading

Table of Contents