Lenovo System x3300 M4 Installation And Service Manual page 78

11. Close the adapter-retention bracket.
12. Perform any configuration tasks that are required for the adapter.
To install an adapter on the PCI-X riser-card assembly, complete the following steps:
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 34.
2. Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 37)
5. See the documentation that comes with the adapter for any cabling instructions and information about
jumper or switch settings. (It might be easier for you to route cables before you install the adapter.)
6. Touch the static-protective package that contains the adapter to any unpainted metal surface on the
server; then, remove the adapter from the package.
7. Locate PCI slot 1 which you will install the adapter into.
8. Rotate the adapter-retention brackets on the PCI-X bracket to the open position.
Note: Remove the expansion-slot cover if it is installed on the PCI-X bracket and save it for future use.
64
System x3300 M4 Installation and Service Guide