Sensor Wiring To Main Board - Emerson Rosemount 1066 Instruction Manual

Instruction Manual
LIQ-MAN-1066

Sensor Wiring to Main Board

4.4
Wire the correct sensor leads to the main board using the lead locations marked directly on the
board. Rosemount SMART pH sensors can be wired to the 1066 using integral cable SMART
sensors or compatible VP8 pH cables. After wiring the sensor leads, carefully take up the excess
sensor cable through the cable gland.
Keep sensor and output signal wiring separate from loop power wiring. Do not run sensor and
power wiring in the same conduit or close together in a cable tray.
FIGuRE 4-6. ph/ORp sensor wiring to the 1066 printed circuit board
Wiring
Section 4: Wiring
April 2017
DWG NO.
40106612
21