Emerson Rosemount 1066 Instruction Manual page 124

Section 10: haRT Communication
April 2017
1066DO
oxygen_sensor_type
The type of oxygen sensor used.
oxygen_measurement_type
The type of oxygen measurement being made.
oxygen_salinity
The salinity of the process solution, which is used by the
transmitter to correct for the effect of salinity on the oxy-
gen measurement.
pressure_units
The units of pressure used by the oxygen measurement.
oxygen_process_pressure
The process pressure used by the transmitter to calculate
percent oxygen in gas or % saturation.
oxygen_air_pressure
The barometric pressure used by the transmitter during an
air calibration.
oxygen_units
The available units used for the various oxygen measure-
ment types.
air_cal_stabilization_time
The period of time used to determine stability of an oxygen
sensor during an air calibration.
air_cal_stabilization_value
The change in the oxygen measurement used to determine
stability of an oxygen sensor during an air calibration.
air_cal_stabilization_value_unit
The unit used during an air calibration.
114
Type Enumeration /
Range
ENUM Water/Waste
Trace Oxygen
BioRx-Rosemount
BioRx-Other
Brewing
Oxygen In Gas
ENUM Concentration in
Liquid
Percent Saturation
Partial Pressure
Concentration in Gas
FLOAT 0.0 - 99.9 ppth
ENUM mmHg
inHg
psi
atm
kPa
mbar
bar
FLOAT
FLOAT
ENUM
Concentration units:
in liquid: ppm
ppb
mg/l
g/l
percent units:
Saturation %
partial units:
pressure mmhg
Oxygen In Gas units:
ppm
%
FLOAT 0 -- 99 seconds
FLOAT 0.001 -- 9,999.0
FLOAT
Instruction Manual
LIQ-MAN-1066
Default
Read/Write
R / W Water/Waste
R / W Concentration
in Liquid
R / W 0.0 ppth
R / W mmHg
R / W 760.0 mmHg
R / W 760.0 mmHg
R / W
ppm
%
kpa mbar
inhg psi
%
R / W 10 seconds
R / W 0.05
R / W ppm
HART Communications