General; Changing The Startup Settings; Purpose - Emerson Rosemount 1066 Instruction Manual

Instruction Manual
LIQ-MAN-1066
Section 7: Programming the Transmitter – Basics
7.1

General

Typical programming steps include the following listed procedures. Each of these programming
functions are easily and quickly accomplished using the intuitive menu system.
• Changing the measurement type, measurement units and temperature units.
• Choose temperature units and manual or automatic temperature compensation mode
• Configure and assign values to the current outputs
• Set a security code for two levels of security access
• Accessing menu functions using a security code
• Enabling and disabling Hold mode for current outputs
• Resetting all factory defaults, calibration data only, or current output settings only
7.2 Changing Startup Settings
7.2.1

Purpose

To change the measurement type, measurement units, or temperature units that were initially
entered in Quick Start, choose the Reset analyzer function or access the Program menus for the
sensor. The following choices for specific measurement type, measurement units are available for
each sensor measurement board.
TaBlE 7-1. Measurements and Measurement units
Signal board
pH/ORP – P
Contacting conductivity - C
Toroidal conductivity - T
Chlorine - CL
Oxygen - DO
Ozone - OZ
Transmitter Programming
available measurements
pH, ORP, Redox
Conductivity, Resistivity, TDS, Salinity,
NaOH (0-12%), HCl (0-15%), Low H
High H SO , NaCl (0-20%),
2 4
Custom Curve
Conductivity, Resistivity, TDS, Salinity,
NaOH (0-12%), HCl (0-15%), Low H
High H SO , NaCl (0-20%),
2 4
Custom Curve
Free Chlorine, Total Chlorine, Monochloramine
Oxygen (ppm), Trace Oxygen (ppb),
Percent Oxygen in gas
Ozone
Section 7: Transmitter programming
Measurements units:
pH, mV (ORP, Redox)
μS/cm, mS/cm, S/cm
SO ,
% (concentration)
2 4
μS/cm, mS/cm, S/cm
SO ,
% (concentration)
2 4
ppm, mg/L
ppm, mg/L, ppb, µg/L % Sat, Partial
Pressure, % Oxygen In Gas, ppm
Oxygen In Gas
ppm, mg/L, ppb, μg/L
April 2017
37