Measurement; Preamp; Filter; Reference Impedance - Emerson Rosemount 1066 Instruction Manual

Section 8: programming Measurements
April 2017
To configure ORP:
1. Press MENu
2. Scroll down to program. Press ENTER.
3. Scroll down to Measurement. Press ENTER.
The adjacent screen format will appear (factory defaults are shown).
To program any displayed function, scroll to the desired item and press ENTER.
The following sub-sections provide you with the initial display screen that appears for each
configuration function. Use the flow diagram for ORp programming at the end of Sec. 6 and the
1066 live screen prompts for each function to complete configuration and programming.
8.3.1

Measurement

The display screen for selecting the measurement is shown. The
default value is displayed in bold type. Refer to the pH/ORP
Programming flow diagram to complete this function.
8.3.2

Preamp

The display screen for identifying the Preamp location is shown. The
default value is displayed in bold type. Refer to the pH/ORP
Programming flow diagram to complete this function.
8.3.3

Filter

The display screen for entering the input filter value in seconds is
shown. The default value is displayed in bold type. Refer to the
pH/ORP Programming flow diagram to complete this function.
8.3.4

Reference Impedance

The display screen for Selecting Low or high Reference impedance is
shown. The default value is displayed in bold type. Refer to the
pH/ORP Programming flow diagram to complete this function.
46
Instruction Manual
LIQ-MAN-1066
1.234 µS/cm 25.0 ºC
SN Configure
Measure: pH
Preamp: Analyzer
Flter: 4 sec
Reference Z: Low
1.234 µS/cm 25.0 ºC
SN Measurement
pH
ORP
Redox
1.234 µS/cm 25.0 ºC
SN Preamp
Sensor/JBox
Analyzer
1.234 µS/cm 25.0 ºC
SN Input filter
04 sec
1.234 µS/cm 25.0 ºC
SN Reference Z
High
Low
Programming Measurements