Changing The Rear Lights (On The Side Panel) - Seat Toledo 2016 Owner's Manual

›››
Remove the bolt Fig. 95
– 1
light grille with a screwdriver.
Subsequently, remove the clips located on
–
the edge of the grille with gentle leverage.
›››
Remove the bolts (3x) Fig. 96
–
move the fog light.
Remove the metal clip situated on the up-
–
per part of the fog light by pulling towards
›››
the exterior of the vehicle Fig. 96
Removing the bulb holder
Front fog light.
Fig. 97
›››
Remove connector Fig. 97
–
bulb.
1)
In the case of LED rear lights of the side panel only
the turn signal lamp can be changed. The illustra-
tions in the manual correspond to the bulb version
and do not correspond exactly to the LED version.
from the fog Turn the bulb holder
–
clockwise and pull.
Remove the bulb by pressing on the bulb
–
holder and turning it counter-clockwise at
the same time.
to re-
2
Installation involves all of the above steps
–
in reverse sequence.
Check that the bulb works properly.
–
.
3
from the
1
Fuses and bulbs
›››
Fig. 97 anti-
2
Changing the rear lights (on
the side panel)
Removing the rear light 1)
Remove the rear light unit from side
Fig. 98
panel.
Check which of the bulbs is defective.
Open the luggage compartment to access
–
the rainduct area.
Take the screwdriver or a Torx 20 key (T20)
–
from the vehicle tool kit and loosen (turn-
ing anti-clockwise) and remove the two re-
taining screws that secure the front of the
›››
light Fig. 98 , taking care not to lose
1
them.
»
87