Check the condition of all seat belts at regu-
lar intervals.
Very soiled belts may not retract properly.
WARNING
The seat belts should never be removed
●
from the vehicle for cleaning.
●
Never clean using chemical products, as
chemical detergents destroy the fabric. En-
sure that the seat belts do not come into con-
tact with corrosive fluids such as acids, etc.
If you find any damage to the belt webbing,
●
belt fittings, the belt retractor or the buckle,
the belt in question must be replaced by an
Official Service.
●
Make sure that the inertia reel seat belts
are completely dry before allowing them to
retract.
Checking and refilling levels
Checking and refilling levels
Fuel
Refuelling
Vehicle as seen from the rear right:
Fig. 203
fuel tank flap/fuel tank flap with tank un-
screwed cap attached.
Read the additional information carefully
›››
page 39
The correct type of fuel for your vehicle is in-
dicated on a sticker on the inside of the fuel
tank flap, along with the tyre size and pres-
›››
Fig. 203
sure
.
Vehicles with a fuel cap with key
Press the flap in the direction of the arrow
–
›››
Fig.
203.
1
Open the cover in the direction indicated
–
by the arrow
.
2
Hold onto the fuel tank cap with one hand
–
and unlock it using the ignition key, turning
it anti-clockwise.
Unscrew the tank cap anti-clockwise and
–
place it on top of the tank flap
.
Insert the pump nozzle into the fuel feed
–
tube as far as it will go.
The fuel tank is full as soon as the automatic
›››
filler nozzle cuts out
.
Remove the pump nozzle from the fuel feed
–
tube and place it back on the pump.
Screw the tank cap clockwise until it clicks
–
into place.
Hold onto the fuel tank cap with one hand
–
and lock it using the ignition key, turning it
clockwise.
Press the tank flap with your hand to close
–
it.
›››
Fig. 203
»
199