Brakes And Brake Servo Systems - Seat Toledo 2016 Owner's Manual

● Immediately after pushing the start-up but-
ton, keep the vehicle key next to the steering
›››
column Fig. 174.
● The ignition connects and the engine starts
automatically.
Emergency disconnection
If the engine does not stop after briefly press-
ing the start-up button, an emergency dis-
connect will be required:
Press the starter button twice within 1 sec-
●
ond or press it once for more than 2 seconds
›››
.
● The engine turns off automatically.
Engine restart feature
If no valid key is detected inside the vehicle
after the engine stops, you will only have 5
seconds to restart it. A warning will display
on the dash panel screen.
After this interval, it will not be possible to
start the engine without a valid key inside
the vehicle.
WARNING
Any accidental movement of the vehicle could
result in serious injury.
● When pressing the start-up button, do not
press the brake or clutch pedal, this way the
engine will start immediately.
152
Operation
WARNING
If vehicle keys are used negligently or with-
out due care, this may cause accidents and
serious injury.
● Never leave any key inside the vehicle
when exiting. Otherwise, a child or unauthor-
ised person could lock the vehicle, start the
engine or connect the ignition and, in this
way, operate electronic equipment (e.g. the
windows).
Note
In diesel vehicles with the Keyless Access
system, there may be a delay in the engine
starting if it requires preheating.
Starting the engine
Vehicles with a diesel engine are equipped
with a glow plug system. When you switch on
the ignition, the glow plug warning lamp 
will light up. The engine can be started
straight away when the lamp switches off.
Do not connect electrical appliances during
preheating so as not the drain the vehicle
battery unnecessarily.
Starting the engine
Move the gearbox lever into neutral or
●
move the selector lever to position P or N and
pull firmly on the handbrake.
● Press the clutch pedal all the way down
›››
and start the engine Fig. 172
3
›››
page 151, without pressing the accelera-
tor. Keep the clutch pedal pressed down until
the engine starts.
● Release the ignition key as soon as the en-
gine starts. The key returns to position
● If the engine does not start after 10 sec-
onds, turn the key back to position
peat the action after 30 seconds.
Release the handbrake before moving off.
●
Switching off the engine with the key
Stop the engine by turning the ignition key to
››› ›››
position Fig. 172 page
1
Brakes and brake servo sys-
tems
Introduction
WARNING
The brake servo only works when the en-
●
gine is running. Braking when the engine is
switched off requires applying more strength
to the brake pedal. Risk of accident!
● Press down on the clutch pedal when stop-
ping and braking with a manual gearbox,
.
2
. Re-
1
151.