Seat Toledo 2016 Owner's Manual page 119

 It lights up
›››
page 118.
Main beam on or flasher on

It lights up
›››
Bulb failure page 83
For example, the information display indicates:
Check front right dipped headlight!
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
WARNING
›››
Observe the safety warnings
and control lamps on page 98.
Note
The rear side lights and number plate light
contain several bulbs. The control lamp 
lights up only when there is a fault in all the
number plate bulbs or side light bulbs (of a
combined tail light). Therefore it is advisable
to regularly check the bulb operation.
Lights and visibility
Side light and dipped beam headlight
Instrument panel: light control.
Fig. 129
Switching on side lights
Turn the light switch
–
.
in Warning
Switching on dipped beam
Turn the light switch
–
.
Switching off lights (except daytime driving
lights)
Turn the light switch
–
0.
Main light range control 
Fig. 130
trol.
Turn the control
–
›››
Fig. 129 to position
to the required setting.
Positions
The control positions roughly correspond to
›››
Fig. 129 to position
the following vehicle load conditions.
Two front occupants, luggage compart-
-
ment empty.
All seats occupied, luggage compartment
1
empty.
›››
Fig. 129
to position
All seats occupied, luggage compartment
2
fully loaded.
Driver only, luggage compartment fully
3
loaded.
Always adjust the range of the lights so that:
Instrument panel: light range con-
›››
Fig. 130 to set the lights
CAUTION
»
117