Seat Toledo 2016 Owner's Manual page 150

● Press the button
AUTO
›››
Adjust vents 3 and 4
●
the air flow is directed slightly upwards.
Change between degrees Centigrade and de-
grees Fahrenheit
Keep the and
AUTO A/C
held down for 2 seconds at the same time.
The data is displayed on the screen in the
units required.
Note
A visit to the specialised service once a
●
year is recommended to clean the Climatronic
system.
The interior temperature sensor
●
›››
Fig. 171 is at the bottom. Do not cover it
with stickers or the like, as this could have a
negative effect on Climatronic operations.
Automatic mode
Automatic mode is used to maintain a con-
stant temperature and demist the windows
inside the vehicle.
Switching on automatic mode
● Set the interior temperature between +16°C
(+64°F) and +29°C (+84°F).
›››
● Adjust vents 3 page 143
the air flow is directed slightly upwards.
148
›››
Fig. 171. ● Press the
13
AUTO
page 143 so that
Automatic mode is switched off by pressing
the air distribution buttons or increasing or
decreasing the blower speed. However, the
temperature remains regulated.
›››
Fig. 171 buttons
Adjusting the temperature
When you switch on the ignition, control
●
›››
Fig. 171
terior temperature.
It is possible to select interior temperatures
from +16°C (+64°F) to +29°C (+84°F). In this
11
range the temperature is regulated automati-
cally. If a temperature below +16°C (+64°F) is
selected, "LO" is displayed on the screen. If a
temperature above +29°C (+84°F) is selected,
"HI" is displayed on the screen. At both ex-
tremes, Climatronic works at maximum cool-
ing or heating power, respectively. The tem-
perature is not regulated.
In the event of prolonged, irregular distribu-
tion of the air flow from the outlets (particu-
larly the footwells) and significant differen-
ces in temperature, e.g. on leaving the vehi-
cle, sensitive people may catch cold.
and 4 so that
Operation
›››
button Fig. 171
AUTO
13
displayed on the screen.
can be used to set the required in-
Air recirculation
and
Air recirculation prevents unpleasant smells,
e.g. when passing through a tunnel or in
queuing traffic, from entering the interior.
Switching on air recirculation mode
● Press button
 17
symbol is displayed on the screen.
Switching off air recirculation mode
1
● Press button
 17
symbol disappears from the screen.
WARNING
Read and observe the safety warnings
General notes on page
Note
If air recirculation mode remains on for 15 mi-
nutes, the  symbol will start to flash on
the screen to indicate prolonged air recircula-
tion. If air recirculation is not switched off,
the symbol will continue to flash for about 5
minutes.
Blower selection
Climatronic automatically regulates blower
speed according to the interior temperature.
›››
Fig. 171
and the 
›››
Fig. 171 and the 
›››
in
142.