Seat Toledo 2016 Owner's Manual page 191

Verify the correct placement of the ball-
–
›››
headed bar page 189.
WARNING
● Do not hold the manual regulator with your
hand when fitting the ball-headed bar since
you could sustain injuries to your fingers.
● When mounting the ball-headed bar, al-
ways lock it with a key and remove the key
from the slot.
● The ball-headed bar must not be in the
service position with the key in the key slot.
If the ball-headed bar is not placed in the
●
service position you will not be able to place
it in the clamping bush.
CAUTION
When removing the key, always place the
cover over the key slot of the manual regula-
tor to prevent dirt from entering.
Note
Once removed, place the clamping bush cap
in an appropriate location in the boot.
Towing bracket device
Verification of correct placement
Correct placement of the ball-head-
Fig. 200
ed bar.
Before using the ball-headed bar, ensure it is
correctly fitted.
Ensure that:
● The ball-headed bar does not come out of
the clamping bush in a "jerky" manner.
›››
● The red mark Fig. 200 on the manual
A
regulator signals toward the white mark on
the ball-headed bar.
The manual regulator is adjusted to the
●
ball-headed bar, leaving no space between
them.
● The regulator is locked and the key has
been removed.
● Cover has been placed over the manual
B
regulator lock.
WARNING
Only use the towing bracket device when the
ball-headed bar is properly fitted!
189