Changing Bulbs For Rear Lights (In Side Panel) - Seat Toledo 2014 Owner's Manual

– Installation involves all of the above steps in reverse sequence.
– Check that the bulb works properly.

Changing bulbs for rear lights (in side panel)

Removing tail light
Check which of the bulbs is defective.
– Open the luggage compartment to access the rainduct area.
– Take the screwdriver or a Torx 20 key (T20) from the vehicle tool
kit and loosen (turning anti-clockwise) and remove the two re-
taining screws that secure the front of the light
taking care not to lose them.
– Pull the rear light unit backwards
light from its housing.
Safety First
Fig. 162 Remove rear
light unit from side panel
⇒ F ig. 162
1
(⇒ F ig. 162 ) to remove the
2
Operating instructions
Remove the bulb holder

– Disconnect the light connector
levers (arrows) and pulling the connector outwards.
– Place the light on a level, horizontal surface on top of a soft
,
cloth so as not to scratch the outer glass.
– Unscrew the four retaining screws from the bulb holder anti-
clockwise using a screwdriver or a Torx 20 key (T20) from the ve-

⇒ F ig.
hicle tool kit 164. Take care not to lose the bulb holder
retaining screws.
Practical Tips
Fuses and bulbs
Fig. 163 Light connector
at the rear of the rear
light unit
Fig. 164 Retaining
screws on reverse side of
rear light unit
⇒ F ig. 163
by moving its side
A
Technical specifications
227
