Seat Toledo 2016 Owner's Manual page 92

Open the cover to access the lights, turning
–
it by hand in the direction indicated by the
arrows.
Access the lights by disconnecting the con-
–
›››
nector Fig. 105  and unscrewing
1
›››
Fig. 105
the bulb holder
to lose the bulb holder retaining screw.
›››
page
Change the bulbs
–
Changing bulbs
Position of the bulbs in the bulb
Fig. 106
holder
The bulbs are secured with a bayonet fasten-
er. The table below gives an overview of the
›››
bulbs table on page 90.
Lightly press the defective bulb into the
–
bulb holder, then turn it anti-clockwise and
remove it.
90
Fit the new bulb, pressing it into the bulb
–
holder and turn it clockwise as far as it will
go.
Use a cloth to remove any fingerprints from
–
the glass part of the bulb.
. Take care not
Check that the new bulb works properly.
–
Re-install the bulb holder
–
90.
Screw in the bulb holder.
–
Position of the bulbs
›››
Fig. 106
A
B
C
Note
One of the two sides may not be fitted with a
fog light, depending on the country and type
of driving. In this case, the hole for the light
is covered.
Fitting the bulb-holder
Position the bulb holder on the tail light
–
and align it so that it is securely seated.
Screw in the bulb holder using the corre-
–
sponding screw.
Emergencies
›››
page 90.
Bulb function
Reversing lights: P21W
Side lights: R5W LL
Fog lights: P21W
Make sure the connector is correctly in
–
place.
Close the inner trim cover.
–
Note
Check the condition of the seal. If damaged, a
replacement can be acquired from an Official
Service.