Cruise Control - Seat Toledo 2016 Owner's Manual

Reading a service notification
With the ignition switched on, the engine off
and the vehicle at a standstill, the current
service notification can be read:
Press and hold the button for more than 5
4
seconds to consult the service message.
When the service date has passed, a minus
sign is displayed in front of the number of kil-
ometres or days.
Vehicles with text messages: Service
since --- km or --- days ago
shown on the display.
The time can also be set via the
function button in the Easy Connect
Setup
›››

system page 99.
Resetting service interval display
If the service was not carried out by a SEAT
dealership, the display can be reset as fol-
lows:
● Switch off the ignition, press and hold but-
›››

ton Fig. 110 .
4
● Switch ignition back on.
›››

● Release the Fig. 110
4
press it again for the next 20 seconds.
Note
● The service message disappears after a few
seconds, when the engine is started or when
is pressed on the windscreen wiper
OK/RESET
lever, or on the multifunction steering
OK
wheel.
In vehicles with the LongLife system in
●
which the battery has been disconnected for
a long period of time, it is not possible to cal-
culate the date of the next service. Therefore
the service interval display may not be cor-
rect. In this case, bear in mind the maximum
service intervals permitted in the
let Maintenance
will be

Cruise control

key and

Operating the cruise control system
(CCS)*
button and
Fig. 39 On the left of the steering column:
switches and controls for operating the CCS
The essentials
›››
Book-
Programme.
● Switching on the CCS: Move switch
›››
Fig. 39 to . The system is on. If no
1
speed has been programmed, the system will
not control it.
● Activating the CCS: Press button
in the  area. The current speed is
2
memorised and controlled.
● Temporarily switching off the CCS: Move
›››
switch Fig. 39 to  or push the
1
brake. The cruise control system is switched
off temporarily.
● Reactivating the CCS: Press button
›››
Fig. 39 in . The memorised speed
2
is saved and controlled again.
Increasing stored speed during CCS regula-
●
tion: press button in . The vehicle ac-
2
celerates until the new stored speed.
● Reducing stored speed during CCS regula-
tion: press button in  to lower the
2
speed by 1 km/h (1 mph). Speed is reduced
until reaching the new stored speed.
Switching off the CCS: Move switch
●
›››
Fig. 39 to . The system is disconnec-
1
ted and the memorised speed is deleted.

›››
in Introduction on page 174

›››
page 174
›››
Fig. 39
31