Seat Toledo 2016 Owner's Manual page 112

Unlocking and locking the vehicle
with Keyless Access
Keyless Access locking and ignition
Fig. 122
system: in the proximity of the car.
Keyless Access locking and ignition
Fig. 123
system: sensor surface
side the door handle and sensor surface
for locking on the exterior of the handle.
Keyless Access is a key-free locking and igni-
tion system to unlock and lock the vehicle
without actively using its key. For this, only a
110
valid vehicle key is required to be in an area
›››
near
sensor surfaces to be touched on the door
handles
General information
If a valid key is located in the proximity of the
›››
car
ignition system gives the key entry as soon
as one of the sensor surfaces on the door
handles is touched or the push button on the
boot hatch is operated. The following fea-
tures are then available without having to
use the vehicle key actively:
● Keyless-Entry: unlocking of the vehicle with
the handles on the four doors or the button
located on the boot hatch.
Keyless-Go: engine ignition and driving. For
●
this to occur, there has to be a valid key in-
side the vehicle and the
● Keyless-Exit: unlocking of the vehicle with
one of the four door handle.
The central locking and locking systems oper-
ate in the same way as a normal locking and
unlocking system. Only the controls change.
for unlocking in-
A
Unlocking the vehicle is confirmed with a
B
double flash of the indicator lights; locking
by a single flash.
The vehicle will lock again after a few sec-
onds if you unlock the vehicle but fail to open
any door or boot hatch.
Operation
Fig. 122 the vehicle and one of the
›››
Fig. 123.
Fig. 122, the Keyless Access lock and
›››
page 151.
Unlocking and opening the doors (Keyless-
Entry)
● Grip the door handle. In doing this, the
›››
Fig. 123
sensor surface (arrow) is
A
touched on the handle and the vehicle un-
locks.
● Open the door.
On vehicles without a "safe" security sys-
tem: shutting and locking doors (Keyless-Ex-
it)
● Switch the ignition off.
● Close the driver's door.
● Touch the surface sensor once (arrow)
B
on the door handle. The door being operated
must be closed.
On vehicles with a "safe" security system:
shutting and locking doors (Keyless-Exit)
Switch the ignition off.
●
● Close the driver's door.
Touch the surface sensor once (arrow)
●
B
on the door handle. The vehicle locks with
›››
page
the "safe" security system
door being operated must be closed.
● Touch the sensor surface twice (arrow)
B
on the door handle to lock the vehicle with-
›››
out the "safe" security system
108. The
page 108.