Seat Toledo 2016 Owner's Manual page 177

use the brake pedal in good time to slow the
vehicle.
Note
In vehicles with an automatic gearbox, the
●
cruise control system cannot be switched on
if the selector lever is in position P, N or R.
In vehicles with a manual gearbox, the
●
cruise control cannot be switched on if first
gear or reverse gear is engaged.
Setting the speed
Fig. 187 Turn signal and main beam head-
light lever: cruise control buttons.
Setting speed
›››
Move knob Fig. 187 to the ON posi-
–
1
tion.
Driver assistance systems
Briefly press rocker switch
– 2
tion when you have reached the speed you
wish to set.
On releasing rocker switch from SET, the
2
current speed is stored and will remain con-
stant without having to press the accelerator
pedal.
Adjust the stored speed
Increasing speed by pressing the accelerator
pedal
Press the accelerator to increase the speed
–
of the vehicle.
Release the accelerator and the previously
–
programmed speed will be resumed.
If, when pressing the accelerator, the vehicle
exceeds the programmed speed by more
than 10 km/h (6 mph) for more than 3 mi-
nutes, the set speed will be deleted. The
speed will have to be stored again.
Increasing speed by pressing switch
›››
Press rocker switch Fig. 187
–
2
›››
page 175 in RES.
If the button is held down in the RES posi-
–
tion, the speed increases continuously. Re-
lease the switch when the required speed
is reached. The speed is stored.
Setting a lower speed
in SET posi-
The set speed can be reduced by pressing
–
›››
switch
2
If the button is held down in the SET posi-
–
tion, the speed decreases continuously. Re-
lease the switch when the required speed
is reached. The speed is stored.
On releasing the switch at speeds of less
–
than 30 km/h (19 mph), no speed will be
set and the memory will be deleted. The ve-
hicle must be moving at a speed of over
30 km/h (19 mph) and switch
again to SET for it to be set.
The speed can be reduced by pressing the
brake pedal, which temporarily switches off
the cruise control.
Temporary deactivation of cruise con-
trol
Cruise control is switched off temporarily by
pressing switch
CANCEL or by pressing the brake or clutch
2
pedal.
The set speed is stored.
To recover the set speed, briefly press switch
in RES once you have released the brake
2
or clutch pedal.
›››
Fig. 187 page 175 in SET.
pressed
2
››› ›››
Fig. 187 page 175 in
1
175